User manual

27
15.5 “Steering exponential” function
Thisfunctionenablesyoutoinuencethesensitivityofthesteering.
Indoingso,thelinearpathbetweenthecontrollerandtheservois
modiedtoanon-linear(exponential)path.Amoresensitivecontrol
about the neutral position is thus possible. The maximum control
pathisnotmodiedwhendoingthis.
“Exp.”:
Thevaluethatcanbesetis-100%to100%,wherebythevalue0%
correspondstolinearcontrol.Amodicationofthesetvaluealways
affectsbothsidesoftheservoendpointequally.
 Negativevaluesleadtostrongerservodeectionsinthe
centre positions.
“Rate”:
Here,theangleofthecurveisset.Thevaluethatcanbesetforthe
angleofthecurvedis0%to100%.Thesmallertheincrease,the
smaller the steering end point.
Selectthe“Activate”button.Then,selecttheparametertobechan-
ged. Slide the regulator to the right or left to change the value to suit
yourrequirements.Selectthe“Activate”buttontosavethecurrent
value. Tap the “Back” button to return to the previous menu.
15.6 “Steering speed” function
This function allows you to coordinate the speed of the steering
servo to suit your model.
“Turn speed”:
Thevaluethatcanbesetfortheturnspeedis0%to100%.
“Return speed”:
Thevaluethatcanbesetforthereturnspeedis0%to100%.The
values in the LC display are displayed in real time. The red bar
symbolisesthepositionofthesteeringwheel,thegreenbarinthe
position of the steering servo.
The values in the LC display are shown in real-time. Thegreen
barsymbolisesthepositionofthesteeringwheel,theredbar,the
position of the steering servo.
Select the parameter to be changed. Slide the regulator to the right
orlefttochangethevaluetosuityourrequirements.Tapthe“Back”
button to save the new values and return to the previous menu.
Figure 15
Figure 16