User manual

25
15.3 “End points” function
Figure 13
Thisfunctioncanbeusedtospecifyhowbigthemaximumpermittedendpointtoeachsideforthesteering,acce-
lerator or additional servo may be. This function is generally used to protect the servos from mechanical stops when
applyingendpointsinfull.Youcansetavaluebetween0-120%.Thesmallerthevalue,thesmallertheservopath
ontherelevantside.Aftercallingthefunction„EndPoints“,youneedtoselectacontrolelementofthetransmitter(e.g.
thesteeringwheel)thatyouwanttochange.Nowtaptheselectedfunction.Thedisplayswitchestoasubmenuin
whichyoucansetavaluebetween0and120fortheselectedpage(markedinred)withthe„controller“(symbolically
displayedasasettingwheel).
Setting the value for the steering servo („Steering“)
UseChannel1(CH1)tosetthemaximumpossiblesteeringendpoint.Todothis,selecttheparametertobechanged
ontheappropriateendpointside(leftorright).Slidetheregulatortotherightorlefttochangethevaluetosuityour
requirements.Tapthe“Back”buttontosavethenewvaluesandreturntothepreviousmenu.
Setting the value for the accelerator servo („Throttle“)
UseChannel2(CH2)tosetthemaximumpossiblemotorrevolutions.Todothis,selecttheparametertobechanged
ontheappropriateendpointside(leftorright).Slidetheregulatortotherightorlefttochangethevaluetosuityour
requirements.Tapthe“Back”buttontosavethenewvaluesandreturntothepreviousmenu.
Setting the value for the additional servos (CH3 and CH4)
UseChannel3(CH3)andChannel4(CH4)tosetthevaluesfortheadditionalservos.Todothis,selecttheparameter
tobechangedontheappropriateendpointside(leftorright).Slidetheregulatortotherightorlefttochangethevalue
tosuityourrequirements.Tapthe“Back”buttontosavethenewvaluesandreturntothepreviousmenu.