User manual

14. Programming the remote control

14.1 Programming the remote control

Thisproductenablesyoutocoordinatethedrive,steeringandswitchingfunctionsofyourmodelindividuallyandto

permanently store the set values. Only a model set to suit the given driver will offer the most fun.

Informationisenteredintotheproductviathetouchscreendisplay.Assoonasyouswitchontheproduct,thefollowing

information will be shown on the LC display.

1 Receiving strength of the receiver

2 Memory number and model name

3 Status display for the transmitter battery pack

4 Statusdisplayforthereceiverbatteries/batterypack

5 RX=displayeldofthesensors

6 Icon bar of the active mixer

7 TX = display of the servo paths and trims

8 Help-menu(intheEnglishlanguage)

9 Main menu

Notes:

Ad 1: The receiver strength of the receiver is permanently transferred to the transmitter by telemetrics and dis-

played.

Ad5: Uptofourmeasuredvaluesofsensorscanbedisplayedinthedisplayelds“RX”.Thedisplayvaluesare

selected in the menu “RX setup”.

Ad 6: Activated mixers or functions are displayed in the icon list.

Ad7: Thedisplayeld“TX”permitstrackingallservopathsbybardisplay.Youcanalsoseethecurrentsettings

fortrimmingofthethrottle(F/B)orsteering(L/R).

Figure 10