User manual

20
13.2 Checking the drive function
 Always carry out digital trimming before checking the drive function. For more information, consult the
section “Starting up the transmitter” in the Chapter “Checking and setting the digital trimming”.
When you pull the accelerator/brake lever for the drive
functionasfaraspossibleinthedirectionofthehandle,
the model should accelerate.
Whenyoupushtheaccelerator/brakeleverforthedrive
functionforwards,themodelshouldbebrakedorswitched
to reverse.
If the control direction should react in precisely the oppo-
sitewaytothecontroldirectiononthetransmitter,thiscan
easily be reprogrammed. See the Chapters “Selecting the
menu” and then “Reverse”.
After you have checked or set the correct drive and stee-
ringfunctions,rstswitchoffthereceiver,thenthetrans-
mitter.
Important!
 Foramodelwithacombustionengine,settherodsfortheexhaustandbrakesteeringinsuchawaythat
theaccelerator/brakeservoisnotlimitedmechanically.Thetrimmingregulatorforthedrivefunction(see
Figure2,Number11)mustbeinthemiddleposition.
 Fora modelwith an electronicdrive regulator, thevarious positions of the operatinglever forthe drive
functions(forwards,stop,reverse)mayneedtobeprogrammedintothedriveregulator.Additionalnotes
regarding this can be obtained from the documentation belonging to the drive regulator.
Figure 9