User manual

18
12.5 Sensor Connections
Plugthecableofthedesiredsensor(1)intothe“SENS”
socketatthereceiver(2).
Installthesensorjustconnectedinyourmodelaccording
toitspurpose(e.g.measuringtemperatureofarecharge-
ablebattery)sothatnocablescangetintorotatingparts
of the drive.
After taken the transmitter and then the receiver into ope-
ration,theLEDinthesensorslightsupinadditiontothe
LEDinthereceiver.
Measurement and transmission to the transmitter is ac-
tivated.
Ifyouwanttouseseveralsensors(1+n)inyourmodelfor
measuringpurposesatthe sametime,connectthenew
sensor(s)simplytotherst(orpresent)sensor.
 Allsensorscanbedisplayedatthetransmitterinthemenu“RXsetup”,inthesubmenu“Displaysensors”.
Youcanhaveuptofoursensorsdisplayedinthemainmenuofthedisplay.Forthis,selectthesequence
andselectionofthesensorsinthesubmenu“choosesensor”.Displayorselectionofthedifferentsensors
is only possible with the transmitter and receiver activated.
12.6 Conguration / Display of the Sensors
Thesensorsconnectedtothemodelandthereceivercanbedisplayedinthemainmenu(i.e.thedisplaythatthat
showstheindicationafteractivationofthetransmitter).Uptofourdisplayscanbeselectedhere.Forinformationon
this,seethechapter“RXsetup”underitem“ChooseSensors”.
Alternatively,youcandisplayallvaluessubmittedbythetransmitter,includingalltheconnectedsensorsinthemenu
“RXsetup”inthefunction“Displaysensors”.
Forthis,observethenotesintheseoperatinginstructions,chapter“RXsetup”,“DisplaySensors”.
SENS
Figure 7b