User manual

12. Connecting a rotation sensor

12.1 Programming the Remote Control

Threesensors are includedin the deliveryof the remotecontrol that can record atemperature, a voltageand a

speed. Up to 15 sensors can be connected to the receiver in series and displayed in different constellations in the

transmitter.

12.2 Temperature sensor

Thetemperaturesensor“CTM01”canmeasure,e.g.,thetemperatureofaspeedbatteryintherangeof-40°Cto

+250°Candtransmitittothetransmitterbytelemetrics.Forthis,attachthetemperaturesensorthatisinstalledtothe

sensorhousinginasuitablelocation,e.g.witharubberbandoradhesivetape.

12.3 Voltage Sensor

Thevoltagesensor“CVT01”canmeasure,e.g.,thevoltageofaspeedbatteryintherangeof4.0Vto100.0Vand

transmitittothetransmitterbytelemetrics.Plugtheconnectioncable,whichisinstalledtothevoltagesensor,tothe

speedbatterywiththecorrectpolarity(e.g.tothebalancerconnection).Theredcablemustbeconnectedtotheplus,

the black to the minus pole of the rechargeable battery. Avoid short circuits and polarity reversal since this may cause

damage.

12.4 Speed Sensor

Thespeedsensor“CPD01”canmeasure,e.g.,thespeed

inthe range of 0 to60,000 U/min andtransmit itto the

transmitterbytelemetrics.Atthetransmitter,youcandis-

playthe speed of the drive wheel.Additionally, you can

displaythedistancedriven(menuitemodometer)and/or

thespeeddriven(menuitemSpeed)withthecorrespon-

ding settings at the transmitter.

Toinstallthespeedsensor,youneedtoattachamagnet

(gure7a,item3)totherotatingpart(e.g.awheelrim–

gure7a,item1)sothatthesensorofthespeedsensor

(g.7a,item2)canslidepastatadistanceoflessthan

orequalto2mm.

Assemblymaterialrequiredforthis(suitableglueforthe

magnet or, e.g., cable ties for the sensor attachment)

are not enclosed with the remote control and must be

purchased separately.

Figure 7a