User manual

16
11.4 Binding function
In order for the transmitter and the receiver to communi-
catewitheachother,theymustbeboundusingthesame
digitalcoding.Whendelivered,thetransmitterandrecei-
ver are already coordinated and can be used immediately.
TherenewaloftheBindingfunctionis,primarily,
only necessary after switching a transmitter or receiver or
when eliminating faults.
ThetransmitterandreceiverarenotboundiftheLEDin
thereceiveronlyashesinspiteofthetransmitterbeing
on.
If the transmitter has lost the binding with the receiver due
toaninterference,orifyouwanttobindanewreceiverto
thetransmitter,proceedasdeclaredbelow.
Removeallservoplugs,aswellasanypresentexternalpowersupply,fromthereceiver(1).Connectthebinding
plug(short-circuitplug)tothereceiveronBIND/VCC(3).Connectareceiverbattery(2)toafreechannel(e.g.CH4).
Switchonthereceiverpowersupply.ThereceiverLEDashesveryfast.Switchonthetransmitternow.
Selectthemenu“RX-Setup”.Selectthefunction“Bindwithareceiver”inthismenu.ThetransmitterasksintheEng-
lishlanguageifyoureallywanttobindtoareceiver.Conrmwith“yes”.
BindingwassuccessfulifthereceiverLEDispermanentlylit.
Nowswitchoffthereceiverpowersupplyandremovethebindingplug.Onlynowcanallservosandanyexternal
power supply be connected again and the receiver be used.
Checkthecorrectfunctionoftheconnectedservos/speedcontrollersbeforeoperatingthemodelandperformarange
check.
 ThetransmittercanalsobeoperatedwiththereceiversoftheremotecontrolsystemsGT2,GT3andGT4.
However,telemetrywillnotbeavailablethen.
 Forbindingthereceiversnamed,thesubmenu“RFstd.”mustbeselectedinthemenu“RXsetup”and,
dependingonreceiverused,either“AFHDS”or“AFHDS2”mustbeselected.
Figure 6