User manual

10. Starting up the transmitter

10.1 Switching on the transmitter

Fortestingpurposes,switchthetransmitteronusingtheOn/Offswitch(seeFigure2,Number7).Thedisplayismade

visiblebythebacklightingnow.Tosavebatterycapacity,thebacklightingisautomaticallydimmedafterawhile.The

backlighting can be activated again by touching the display. Brightness settings and setting of the time until dimming

ofthebacklightingareexplainedinchapter“SettingsintheMainMenu/System”.

Pushtheon/offswitchagaintodeactivatethetransmitter.Itmustbepushedforaboutthreeseconds.

 Ifthesetting“Systemsound”isactivatedinthe“System”menu,signalsoundsareoutputatmenuchange

andinput.Additionally,asoundisgeneratedwhenswitchingon/off.

10.2 Checking and setting the digital trimming

Before you can carry out setting work on your model or

start with the programming of your product, you must

ensure that the digital trimming for the steering and drive

functionissettothemiddleposition(0).

Middle position of the steering function

Usingthe“TR2”trimmingbuttonforthesteeringfunction,

setthemiddlepositionforthesteeringservo(ST).Todo

this,pressthe“TR2”trimmingbuttoneithertotheleftor

to the right in order to set the value to 0. If you hold down

thetrimmingbutton,thevaluewillbechangedconstantly.

Thevaluecanbeadjustedbetweenleftandrightatupto

120 steps each.

 Every shortoperation of theprogramming and settingbuttons is conrmedby an acoustic signal when

the“Systemsound”settingisactivated.Ifabuttonispushedforalongerduration,thevalueswillchange

continuallyandthetransmitterwillemitafastsequenceofsounds.

 Whenyouperformtrimming,a sub-menu willopen.Thedisplaywillshowtrimming forsteeringandthe

throttle/brakeleverinlargeformat.Whenendingtrimming,thisdisplaywillautomaticallyreturntothebasic

menu. The set trim value is also displayed here.

Figure 4