User manual
22
18. Servo Path Limitation
Use the servo path limitation or the dual rate function to reduce the servo deections of channels 1, 2 and 4 from
100% to 60%. You can use this function to simply and easily reduce the reaction sensitivity of a model which reacts
too aggressively at full extension.
Especially when a model is used for the rst time, it might not yet be clear how sensitively it responds to the control
commands. Therefore it is a proven method to reduce large rudder deections during ight.
The path limitation is switched with the switch at the upper left of the remote control transmitter (also see gure 1,
item 15).
If the switch is switched to the upper/front position ( ), 100% servo path are available.
If the switch is switched to the lower/rear position ( ), 60% servo path are available.
Figure 15
The rudder path reduction amount of 60% is xed ex works and cannot be changed by the user.