User manual

15. Switching the Servo Directions of Travel

If the rudder movements are not according to gure 10,

you can switch the running direction of the servos at the

receiver outputs "CH1" to "CH 4" at the reverse switches

(also see gure 1, item 9). The switches at the transmitter

are assigned as follows:

"AIL" = Aileron/roll servo "CH 1"

"ELE" = Elevator servo "CH 2"

"THR" = Throttle servo/ight controller "CH 3"

"RUD" = Rudder/tail servo "CH 4"

If the switch is in the bottom position, the "regular" running

direction is set. If the switch is pushed to the top position,

"reversed" running direction is activated.

Please observe that the centre position of the servo/rudder may have to be adjusted after switching.

For the switching channel "CH 5", switching of the servo running direction at the transmitter is not possible.

Figure 12