User manual

Before using the model boat, check that the water cooling system is working properly. Attach a small piece of tube to

the water cooling intake (on the bottom of the hull) and blow air into the tube. The air (or water when the model boat

is moving) must come out of the outlet on the side of the hull.

The opening on the hull must be kept clean, otherwise the water cooling system will not function properly, and the drive

components may overheat and become damaged. This will void the warranty.

Do not use the model boat if the tubes are blocked, kinked or damaged, otherwise the water cooling system

will not function properly.

Carefully place the boat into the water and ensure that it is level. Make sure that the rudder and propeller are above

the ground and that the propeller can spin freely.

Gently pull the throttle lever in the direction of the handle. The boat will start to move forwards. To change the direction

of travel, move the steering wheel on the remote control left or right as desired.

The battery life is approximately 7 to 8 minutes. This may vary depending on the battery capacity and how you drive

the model boat. Bring the boat back to the edge of the water before the battery runs out. Open the hull and discon-

nect the battery. Switch off the remote control and check whether any water has leaked into the boat. If so, drain the

water immediately by turning the hull. Do not allow the draining water to come into contact with the remote control

and drive components.

It is normal for small amounts of water (max. 10 ml) to enter the model. Always ensure that any water is emptied after

each use.

Leave the motor and speed controller to cool down to the ambient temperature after use. Wait for 5 - 10 minutes

before using the boat again. Leave the hull open to allow the components to cool down more quickly.

Practical tips:

If the amount of water that leaks into the boat starts to increase, this usually indicates that there is no

lubricant left in the shaft. If this occurs, the shaft may need to be removed and lubricated. Refer to the

instructions in section 12.

IfthespeedcontrollerturnsoffthemotorunexpectedlyandtheredLEDisashingonthereceiver,thisindicates

that the speed controller is not receiving a signal from the receiver. Establish the cause of the problem (the receiver

antenna may be wet or hidden inside the hull) and take appropriate action.