User manual

To do this, move the steering wheel on the remote control to the neutral (central) position, and then set the trim to the

neutral position. Use a suitable hex key to loosen the pushrod connection on the rudder system's steering linkage.

Adjust the steering linkage until the rudder is straight, and then tighten the screw on the pushrod connection.

 Metalscrewconnectionsmustbesecuredwithlocknutsoradropofthread-lockinguidtopreventthem

from becoming loose.

Movethesteeringwheeltotheleft(anticlockwise,seegure4).Therearedgeoftherudder(viewedfrombehind)

should move to the left.

Movethesteeringwheeltotheright(clockwise,seegure4).Therearedgeoftherudder(viewedfrombehind)should

move to the right.

Figure 4

Checktheforwardthrottle.Movethethrottleontheremotecontrol(seegure5)toadjustthespeedoftheship.

The more you pull the trigger towards the handle, the faster the propeller will spin and the faster the boat will move.

The propeller rotates in an anticlockwise direction (when viewed from behind). The motor is off when the lever is the

central position.

Reversing is possible by pushing the throttle on the remote control away from the handle.

Figure 5