Instructions

going to replace for the receiver, follow the steps below for the pairing:
Turn on transmitter. Connect the “S” and “-” of TH channel output. Then turn on
the receiver, the LED light on the receiver should be fast blink, within 5 seconds LED
light should stay on, pairing complete.
Receiver LED light State
1. LED light stays on: transmitter and receiver has been paired, work properly.
2. LED light off: receiver does not pick a signal from transmitter: 1. transmitter is not
on; 2. pairing has not been done yet.
3. LED light blink once a second: battery voltage is low.
4. LED light keeps fast blink: under pairing mode.
Beep Meaning
1 Short beep: The battery is NiMH.
2 short beeps: The battery is 2S Lipo.
3 short beeps: The battery is 3S Lipo.
1 long beep: the ESC is ready to run.
Fail Safe
Fail safe feature build in receiver. When receiver stop communication with
transmitter, ESC will stop outputting, then steering channel output will maintain the
latest position.
Low Voltage Warning
Low voltage warning feature build in receiver.
If the voltage of battery is lower than 3.3V per series(LiPo) or 5.2V total(NiMH),
the ESC will enter the protection mode, so the motor max speed will be limited to
50%.
If the voltage of battery is lower than 3 V per series(LiPo) or 5V total(NiMH),
the car will stop.
Installation and Use Guide
The remote control is a 2.4G wireless products, a proper installation and usage
will exert influence on performance of the product.
Due to the poor penetration of 2.4G signals, it is necessary to ensure that
transmitters and receivers are used without occlusions in order to ensure reliable
communication;
A build-in 2.4G signal receiving module inside the receiver, so keep it away as
far as possible from other electronic products, motors, etc., to reduce interference;
A build-in antenna is inside the transmitter of the remote controller. The antenna is
vertically installed. So keep the remote controller in a vertical position when using;
The remote controller receiver has an antenna, ensure that the antenna keep vertical
position to the ground during the installation, and keep any metal materials away near
the antenna.