Instructions

13
5.2.1 Switching modes (Mode 1/Mode2)
1. Initiatemodeswitching:
- For Mode 2:Movetheleftjoysticktothelowestpositionandholddownthe<OneKeyTakeoff/Landing>button
at the same time.
- For Mode 1:Toggle therightjoystick tothelowestposition andholddown the<Photo/Video>buttonatthe
same time.
2. Whileholdingdownthebuttonfromstep1,turnontheremotecontrollerbypressingthe<Power>buttonuntil
youhearabeepsound.
3. Releasethejoystick.Themodeischanged.
5.3 Flying – Getting ready for take-off
Requirements
• Theightbatteryandtheremotecontrollerbatteryarefullycharged.
• You understand what the controls do.
5.3.1 Powering on and initializing the aircraft
WARNING
Alwayspowerontheremotecontrollerbeforeyouturnontheaircrafttopreventaccidents.
1. Puttheaircraftonaatsurface.
2. Powerontheremotecontroller.Holddownthe<Power>buttonfor2seconds(Fig.A).
3. Powerontheaircraft:
- Pushthe<Power>buttononce(1x),thenpressagainandholdfor2seconds(Fig.B).
- Theinitializingtuneplays.
4. Waitfortheself-checkandfrequencymatchingproceduretocomplete.
- Theproceduretakesabout30seconds.
- Whentheindicatorlightsturnfromashingorsolidbluetoashingorsolidgreentheprocedureiscompleted
(Fig C).
Fissssssss Fig. A sss Fig. B Fissssssss Fig. C