User manual

15. Use of Your Own Remote Control System

(ARF-Version)

TheracecopterintheARF-version(itemno.1409645)isdeliveredwithapre-conguredCC3D-ightcontroller.The

CC3Dightcontrollerisbasedonthe"OpenPilot"/"LibrePilot"softwareandcanbeconguredusingthis.Youneedto

adjustyourremotecontroltotheCC3Dightcontrollerforthis.

Foradetailedinstructionandthecongurationsoftware,see:

http://www.librepilot.org

https://opwiki.readthedocs.org

To connect the racecopter to the "OpenPilot"/"LibrePilot" software, you need a suitable USB cable (USB-plug type A

tominiUSB-plug)andtheabovecongurationsoftware.

Attention!

 Removethepropellersoftheracecopterwhenconguringit.Uncontrolledsuddenstart-upofthepropellers

may cause considerable damage to you and your environment.

Establishtheusualbasiccongurationatyourtransmitterandconnectthetransmittertoyourreceiver.Itisrecom-

mended to put all trims into the neutral position.

a) Connection with the Receiver

ConnecttheconnectioncableoftheCC3Dightcontroltoyourreceiver.Thefollowinggureshowstheoccupationof

theightcontrolatthe6-pinplug(observeorder).

1 Black cable:

 CH6->Notassigned

2 Yellow cable:

 CH5->Flightmode

3 Green cable:

 CH4->Yawfunction

4 Yellow cable:

 CH3->Pitchfunction

5 Violet cable:

 CH2->Nodfunction

6 Black-white-red cable:

 CH1->Rollfunction

(and voltage supply)

Figure 32