User manual

For installation of the camera, place the racecopter on a level surface to install the FPV system.

DisconnecttheLiPoightbatteryentirelyfromtheracecopterbeforeinstallation.Takeitoutofthebatteryholder.

Proceed with care for installation and do not apply any force.

To install a camera, remove the four screws (2) from the spacers (4, 5) at the top of the racecopter. Remove the as-

sembly (3) and the camera holder (1) from the racecopter.

Insertthecameraintothecameraholder(gure27,item1)sothatthewritingislegiblewhenthetwotabsinthe

cameraholderpointup(seegure28).

Attachthecamerawiththeenclosedsheetbracketandthetwoscrewsinthecameraholder.Ifthecameraisnotrmly

placed in the holder, remove the sheet bracket again and bend it into a slight U-shape so that the bent side will push

onto the camera housing and fasten it this way.

Figure 27

Figure 28