User manual

67
12. Binding Function
To enable transmitter and receiver to work together, they must be bound by the same digital code. In the delivery state,
transmitter and receiver are aligned with each other and can be used at once.
The binding settings must be renewed mainly after a replacement of the transmitter or receiver or to remove any
interferences.
Before you can bind the receiver to the transmitter, check if the transmitter works in the right digital code (see previ-
ous chapter).
To perform the binding procedure, proceed as follows:
• Transmitterandreceivermustbeindirectproximity(distanceapprox.50cm).
• Switchoffthetransmitter.
• Disconnectanyservosthatmaybeconnectedfromthereceiver.
• Connecttheenclosedprogrammingplugtothe"BAT"connectionofthereceiver.
• Thepowersupplyofthereceiver(receiverbatteryorspeedcontrollerwithBEC)isconnectedtoanyoutputofthe
receiver.
• Switchonthereceiver.ThereceiverLEDstartstoashquickly.
• Pressthebindingbuttonatthereceiver(1)andkeep
the button pressed.
• Switchonthe transmitterwiththeon/offswitchwith
the binding button pushed. The LED display in the
transmitterstartstoicker.
• WhentheLEDinthereceiverashesslowlyaftera
few seconds, binding, binding has been completed.
• Releasethebindingbuttonatthetransmitter.
• Switchoffthereceiverandtransmitterandremovethe
programming plug.
• Re-connecttheservos/controllerstothereceiver.
• Checkthefunctionofthesystem.Ifthesystemisnot
working properly, perform the process again or check
the digital code of the transmitter.
Figure 24
1