User manual

f) Connecting the Flight Batteries

Movethecontrolstickforthepitchandyawfunctions(alsoseegure2,item15)tothebottompositionandswitch

(gure2,item3)totheoppositionandswitchonthetransmitterwiththeon/offswitch.Placetheracecopterontoa

horizontal, level surface.

Then connect the racecopter connection (1) protected

against polarity reversal to the plug connector of the

ightbattery.

The LED strips (1, 2) at the bottom of the racecopter

are lit permanently after pushing in the rechargeable

battery.

To recognise the position of the racecopter in the air

well, the LED strip at the front is lit "red" and the LED

strip at the rear of the racecopter is "white".

After connecting the battery, the electronic in the

racecopter performs an internal reconciliation (initiali-

sation) for approx. 5 seconds. During this time, the blue

LEDickersveryquicklyinightcontrol;theracecopter

must not be moved or turned during this.

Onceinitialisationiscomplete,theblueLEDwillash

much more slowly (approx. 2 Hz). Now your racecopter

is ready to start.

Figure 10

Figure 11

Figure 12