User manual

66
11. Switching the Digital Code
The remote control transmitter enables you to control receivers with the digital code "AFHDS" and "AFHDS2A".
Since the receiver works with the code "AFHDS2A" in the RtF-version (item no. 1407577), the transmitter is pre-
conguredfor"AFHDS2A"aswell.
Ifyouwanttooperateareceivermatchingthetransmitterwiththedigitalcode"AFHDS"(e.g.inanotherightmodel),
thetransmittermustbeswitchedrstandthenthereceivermustbeboundtothetransmitter(seefollowingchapter
12).
To switch the digital code at the transmitter, proceed as follows:
• Switchoffthetransmitter.
• Movethetwocontrol leverstothelowerleft corner
and keep them there.
• Switchonthe transmitterwiththeon/offswitchwith
thecontrolleversdeected.
• Releasethetwocontrolleverssothattheymoveto
the centre position.
• If the LED display ashes, the transmitter has
switched to the digital code "AFHDS". If the LED dis-
playashesandtheremotecontrolalsoissuesshort
signal sounds in a cycle of one second, the transmitter
has switched to the digital code "AFHDS2A".
• Switchoffthetransmittersothatthecurrentlysetdigi-
tal encoding is saved.
Important!
The receiver installed in the RtF version (item no. 1407577) works with code "AFHDS2A". Therefore, always
observe that the right code is programmed at the transmitter!
Figure 23