User manual

Fit the propeller to the motor mount and tighten the nut, then install the spinner by tightening the 2

screws. Please be careful of prop orientation. Normally the side with characters faces forward.

Lastly connect all clevis to control horn using the third hole on the control horn. Please adjust the

clevis to make sure the flap, aileron, rudder and elevator should be centered after connection.

Flap Servo

Rudder Servo

ESC

Elevator Servo

Aileron Servo

Step 5: Mount the spinner,propeller and connect the control horns

Assmbled product as shown below

Before flying your W-2000 be certain to follow all of the instructions accompanying

your radio control system for charging the transmitter batteries and performing a

range check.

Section 1:Connect the receiver

2 aileron servos are connected to CH1 with a Y connector,Elevator servo to CH2,ESC

to CH3, Rudder servo to CH4,Flap servo to CH5 or CH6.

ADJUSTMENT BEFORE FLIGHT