User manual

61
• Pushthecontrolleverforthemotorfunctionslowlyfromthebottomtothetopposition.Therotorwillstartupand
increase speed depending on control lever position.
• Whenthecontrolleverisatthetopstop,themaximumrotorspeedisreached.Thenmovethecontrolleverbackto
the bottom-most position.
• Performabriefenginetestandchecktherunofthepropellerandthepropellercatch.
• Disconnecttheightbatteryfromthemodelandswitchoffthetransmitter.
Figure 17
e)SettingtheRudderDeections
Iftheconstructionisperformedandthetransmittersetcorrectly,theruddersshouldhavethefollowingrudderdeec-
tion values:
Aileron 12 mm upwards 12 mm downwards
Elevator 12 mm upwards 12 mm downwards
Rudder 25 mm to the left 25 mm to the right
Attention!
 Theindicatedvaluesshowtherudderdeectionstobeselectedfortherstights.
 Adjustthedeectionstoyourpersonalpreferencesafterafamiliarisationperiod.
The enclosed remote control system does not permit setting of the servo paths at the transmitter and thus
therudder deectionsatthemodelasmoreexpensivecomputer-basedremote controlsystemsdo.To
changetherudderdeections,thedesiredvaluesaresetbyrepositioningthepushrodsontheservoarms
ortheaps.