User manual

Rudder function

Ifthecontrolstickfortherudderfunctionismovedtotheleft,theruddermustdeecttotheleft.Therearrudderedge

mustbedeectedtotheleftbyapprox.25mm.Inight,thelandinggearispressedtotherightandthemodelies

to the left.

Figure 14

Ifthecontrolstickfortherudderfunctionismovedtotheright,theruddermustdeecttotheright.Therearrudder

edgemustbedeectedtotherightbyapprox.25mm.Inight,thelandinggearispressedtotheleftandthemodel

iestotheright.

Figure 15

 Iftherudderdoesnotdeectasdescribedabove,the"Servo-Reverse"functionatthetransmittermustbe

used to change the running direction of the servos. Further information on this can be found in the operating

instructions for the remote control.

Motor Function

Attention!

 Ensurethatnolooseparts,suchaspaper,lmorotherobjectscanbesuckedintotherotorduringthismotor

test. Also make sure that the model is held securely during this test run and that no clothing and body parts

are within the rotation range or danger area of the rotor.

• Pushthecontrolleverforthemotorfunctiontothebottomposition.

• Firststartthetransmitter,thenthemodel.Dependingonhowtheightcontrollerisprogrammed,theightcontrol-

ler'sreadinessforoperationissignalledbydifferentsounds.

Figure 16