User manual

58
d)VericationoftheControlFunctions
Beforestartingyourmodelforthersttime,youneedtofamiliariseyourselfwiththeremotecontrol,thecontrolfunc-
tions and test the model functions. The functions and commissioning of the remote control system can be taken in the
operating instructions separately enclosed with the remote control.
Alwaysturnonthetransmitterrstandputthespeedcontrolleverto"Motoroff"(seegure16).
Connecttheightbatterytotheightcontroller(seegure8,item2).Theightcontrollernowchecksthe"Motoroff"
controlsignalofthetransmitter.Dependingonhowtheightcontrollerisprogrammed,theightcontroller'sreadiness
for operation is signalled by different signal sounds.
 Thesignalsoundsaregeneratedbyashortstart-upofthemotorbytheightcontroller.
 Theightcontrollerhasanundervoltagerecognitionthatswitchesoffthemotorataspecicvoltagedepend-
ingonbatterytype.Thusavoidsaharmfuldeepdischargeoftheightbattery.
 Theightcontrollerisalreadycorrectlypre-programmedexworks.Chapter13containsfurtherinformation
on this.
Neutral Position:
When the control lever for the rudder, elevator and aileron functions and the respective trimming is precisely in the
centreposition,therudder,elevatorandaileronattheightmodelshouldbepreciselycentred.
Viewedfromtherear,theruddersandelevatorsmustformalevelwiththerudderandmustnotbedeectedtothetop
or bottom, left or right. The ailerons must be at one level with the wings.
If the ailerons and/or rudders or elevators are not aligned precisely, the rudders can be aligned precisely with the
linkage wires by twisting the clevises.
Elevator function
Ifthecontrolstickfortheelevatorfunctionismoveddown,theelevatormustdeecttothetop.Therearrudder
edgemustbedeectedupwardsbyapprox.12mm.Inight,thelandinggearispresseddownwardsandthemodel
ascends.
Figure 10