User manual

c) Setting of the Centre of Gravity

Themodelairplanemustbesetbyproperplacementoftheightbattery(and,ifrequired,byadditionoftrimminglead)

so that the centre of gravity is approx. 85 mm behind the nose strip of the wing.

Todoso,markthecorrespondingcentreofgravitypositionatthebottomofthewingwithapen.Useyourindexngers

(oradeviceintendedforthis)toholdtheassembledandready-to-ymodelfrombelowatthemeasuredpositions.

If the centre of gravity is set correctly, the model airplane should be leaning slightly forward.

Important!

 Alwaysmeasurethecentreofgravityready-to-ywiththecabinhoodinplace.

 Fortherstights,setthecentreofgravityatapprox.82mmwingdepthinsteadofat85mm.Thebest

centre of gravity then can be reset slowly.

Figure 9