User manual

d) Mounting the Wing

The wings are installed in the fuselage slots on the left and right. For this, push the enclosed wing rod (2) into the wing

(1). The wing rod is later secured with one screw each with the wing pushed on. To install the wing rod, these screws

mayneedtobeturnedoutalittleatinitialassembly(seegure7).

Push the wing rod (2) into the hole of the middle fuselage part. Insert the plug of the aileron servo into the fuselage

and plug it into the Y-cable at the receiver (3). Always observe the correct polarity. The minus line is black or brown at

the outside at the plugs and must meet the same colour at the counterpiece.

Carefully push the wing rod into the wing half and the wing into the cut-out at the fuselage until the shaping of the wing

isushwiththefuselage.Observethattheservocableisnotcaughtandpushedintothefuselage.

Then install the second wing half on the fuselage in the same manner.

Figure 6