User manual

c) Checking the Linkage Rods at the Ailerons

The linkages of the ailerons are pre-installed ex works (1). Also check if the rudder horns of the linkage rods are in the

second-to-last, outer position of the rudder horns (2).

In the neutral position of aileron trimming and control lever, the ailerons need to be in the neutral position as well and

endush(3)withtherearwingedge.Ifthisisnotthecase,theaileronsmustbeadjustedbytwistingtheclevisesin

or out.

The connection of the aileron servos is described in the following chapter 8. d). The correct function is explained in

chapter 10. d).

 Thewingsoffertheoptionofinstallingadditionalwingaps.Thewingshavealreadybeenpreparedfor

this.

The material needed for this (servos, cables, linkage parts, etc.) are not included. Since this conversion re-

quires craftsmanship, model-building skills and a computer remote control, the conversion is not described

inanymoredetailintheseoperatinginstructions.Thewingapsmustbeactivatedaccordingtoyourown

discretion.

 Thewingapsarenotneededforoperationasabeginner'smodel.

Figure 5