User manual

9. Model Setup

Before assembling the model, please read each individual section carefully. The construction stages are

illustrated for better understanding.

For design and colour of your model and the remote control, use the illustration, e.g. on the packaging for

reference.Designandcolourdeviationsintheseoperatinginstructionsarepossible.Theguresinthese

operating instructions only serve illustration.

Only carry out the steps described in the different sections if you have completely understood the procedure

and know exactly what to observe.

 Liftoffthecanopyforthefollowingwork.Itisfastenedtothefuselagewithamagnet(alsoseegure8,item

3). To lift it off, pull the canopy up a bit vertically at the ventilation entrance at the motor pylon.

a) Mounting the Elevators and Rudders

Figure 2

Place the rudder (1) in the intended slot in the elevator (2).

Imprecisetsshouldbecarefullycorrectedwithacutterknifeand/ornesandpaper.Alsocheckifinstallationatan

angle of 90° is possible without problems.

When everything is perfect, attach the elevator with the rudder to the fuselage with a M4 x 45 mm screw (3).