User manual

13. The System Setting Menu „SYSTEM“

Thebasicsettingsoftheremotecontroltransmitteraremadeinthesystemsetupmenurst.Thesesettingsarenot

referredtoindividualmodels.Thespecicsettingsoftheindividualmodelsareonlymadeafterwardsinthefunction

setting menu (see chapter 14).

To get to the system settings menu, switch the transmitter on and push the „SELECT“ button. The operation of a button

atthetransmitterisconrmedbyashortsignalsound.

The display shows the two main menus „Function“ and „System“. The menu „Function“ already has a black back-

ground. You can use the buttons „UP“ and „DOWN“ to give the menu „System“ a black background and call it by

pushing the „SELECT“ button again.

Therst4menuitemsofthesystemsettingmenuarenowdisplayed.

The following setting functions are available to you in the system setting menu:

Function Display

Model name settings „1: MDL NAME“

Model memory selection „2: MDL SEL“

Copying model memory „3: MDL COPY“

Reset model memory „4: MDL RST“

Model type selection „5: MDL TYPE“

Control stick assignment „6: STK TYPE“

Calibrate pitch stick middle position „7: STK ADJ“

To leave the system setting menu again and to return

to the operating system, push the „CLEAR“ button

twice.

Figure 22