User manual

If the adjustment areas of the nod and roll trimming are not quite adequate for an optimum correction, you

adjust control of the main rotor blades mechanically. For further information, refer to the following chapter

11 „Fine-tuning the model helicopter“.

Pitch trim:

Adjustthepitchvaluetothemiddlevalue(highersignalsound)withthetrimbuttonforpitchtrimming(seegure1,

item 16). The helicopter should then hover at a consistent height if the control stick for the pitch function is in its middle

position.Ifrequired,youcancorrectthecontrolstickpositionwherethehelicopterisinhoverightwiththetrimbutton.

Caution, important!

If you push the trim button up repeatedly until the upper end position of the pitch trimming is reached, the

rotorsofthehelicoptermayalreadystartupiftheightbatteryisconnected,eventhoughthecontrolstick

for the pitch function is still in the bottom position.