User manual

85
h) Trimming the Model Helicopter
First start the transmitter, then the model.
Pushthepitchstick(alsoseegure1,item17)fromthebottomposition(engineoff)carefullyforwardandobservethe
response of your model. Shortly before the helicopter starts hovering, you can already determine in which direction
your model wants to move.
Tail trimming:
If the helicopter is to turn to the right with the tip of the fuselage, reduce the speed until the helicopter is standing safely
onitsskidsagain,andthenpushthetrimbuttonforthetailfunction(alsoseegure1,item15)repeatedlytotheleft.
Pushthepitchstickcarefullyforwardandcheckiftheadjustmentwassufcient.Keeprepeatingthisprocedureuntil
the helicopter no longer has any tendency to turn to the right.
If the tip of the fuselage turns to the left, press the trim button for the tail function to the right.
Figure 17
 Everyoperationofabuttonisconrmedbyashortsignalsound.Thedisplayshowsthechangeofthetail
trimmingatthetrimmingdisplay(seegure5,item8).
If the button is pushed and held, the remote control will emit a quick sequence of signals and the trim dis-
play will move sideways more quickly. The trim middle setting is indicated by a higher signal sound. The set
value for tail trimming is automatically saved and must be re-adjusted after each activation of the remote
control.