User manual

73
9. Setting up the Transmitter
 Inthefurthercourseoftheseinstructions,guresinthetextalwaysrefertotheadjacentgureorthegures
withinthesection.Referencestootherguresareindicatedwiththecorrespondinggurenumber.
a) Inserting the Batteries
The power supply of the transmitter requires 4 AA/mignon batteries (e.g. Conrad Item no.: 652506, order 4x).
Important:
Use batteries only (1.5 V/cell) instead of rechargeable batteries (1.2 V/cell) for transmitter power supply.
Proceed as follows to insert the batteries:
Liftthebatterycompartmentlid(seegure2,item24)atthe
lower edge and fold it up.
Insert four type AA/mignon batteries with correct polarity (ob-
serve plus/+ and minus/-) according to the specications at
the bottom of the battery compartment (1). The spiral-shaped
spring contact (2) always must be connected to the minus pole
of the battery (3).
Fold down the battery compartment lid and let it latch.
b) Switching on the Transmitter
Move the control stick for the pitch and tail functions (also see
gure1,item17)tothebottompositionrightatyourbody.
Check the position of the toggle switches. All switches should
beintheforwardorbottompositions(seearrowsinthegure
on the right).
Slidetheon/offswitch(alsoseegure1,item7)fromthelower
switch position (off) up to the position (on).
Figure 3
Figure 4a