User manual

114
k) Mixer Programming „PRO MIX1“ and „PRO MIX2“
Theremotecontrolofferstheoptionofmixingtwocontrolchannels.Inaightmodel,thefunctionisusedoften,e.g.
toalsoautomaticallygenerateanelevatordeectionwhenextendingthelandingorspoileraps,sothatthemodel
airplanedoesnotchangeitshorizontalightposition.Forthehelicoptermodel„HCP803D“,thesemixersarenot
needed and therefore need to be switched off.
Proceed as follows for mixer programming:
• Call the function settings menu.
• Select the menu item „PRO MIX1“ or „PRO MIX2“ with the
buttons „UP“ or „DOWN“.
• Activate the menu item with the button „SELECT“.
The display shows the master and slave functions as well as
the setting values for the mixing shares and the offset value.
All displayed setting values should be set to „0“ and the func-
tion of the mixer should be off (setting „SW: INH“).
• Pushthebutton„SELECT“tocallthespecicsettingvalues
when required.
• Pushing the buttons „INC (+)“ or „DEC (-)“ permits changing
the set values or setting them to „0“.
• Set all setting values to „0“ and switch off the mixer (setting
„SW: INH“), if it is activated.
• The setting is saved automatically.
• Push the button „CLEAR“ to get back into the overview of the
function setting menu.
Figure 46