User manual

112
i) Swash Plate Servo Setting „SWASH MIX“
In this menu, you can adjust the mixing ratio of the swash plate servos to each other. In this way you can perfectly
setthecorrectmovementdirectionandtherequiredangleofdeectionorshiftpathoftheswashplateinreactionto
the transmitter control signals.
Proceed as follows to set the swash plate servo:
• Call the function settings menu.
• Select the menu item „SWASH MIX“ with the buttons „UP“
or „DOWN“.
• Activate the menu item with the button „SELECT“.
The display shows the set values of the three swash plate
servos and the linkage type „3 Servos 120“.
If any other linkage type is displayed, the model helicopter
„HCP80 3D“ requires the corresponding setting in the system
setting menu, menu item of the model type selection (chapter
13 e). The triangle pointing to the right at the set value „AILE“
shows that the setting for the rolling function can be made.
• Pushing the buttons „INC (+)“ or „DEC (-)“ sets the lateral
inclination of the swash plate for the rolling function. The
higher the set value, the higher the movement of the swash
platewhenthecontrolstickreachesitsfulldeection.Byset-
tingavaluewithnegativeprex,themovementdirectionsof
the swash plate changes.
• The setting is saved automatically.
• Push the button „SELECT“ to set the swash plate movement
for the pitch function „PIT“. The pitch value setting (lifting and
lowering of the swash plate) takes place according to the
same principle as in the roll function.
• Push the button „SELECT“ again to set the required swash plate movement in the nod function „ELEV“ as well.
• Push the button „CLEAR“ to get back into the overview of the function setting menu.
Figure 44