User manual

107
To set the gyro sensitivity, proceed as follows:
• Call the function settings menu.
• Select the menu item „GYRO SEN“ with the buttons „UP“ or
„DOWN“.
• Activate the menu item with the button „SELECT“.
• The display shows the display of the gyro sensitivity for the
switch positions „POS0“, „POS1“ and „POS2“. Since the rock-
er switch can only call the positions „POS0“ and „POS1“, the
setting „POS2“ is not relevant and can be left on 0.
• The triangle pointing to the right shows that the value for the
switch position 0 (switch position to the front) can be set.
• Pushing the buttons „INC (+)“ or „DEC (-)“ permits changing
the value of the gyro sensitivity in the area from 0 to 100.
• The setting is saved automatically.
• Push the button „SELECT“ so that the triangle pointing to the
right will jump down to the switch position 1 (switch position
to the rear).
• The setting is made the same way as that for switch
position 0.
• Push the button „CLEAR“ to get back into the overview of the
function setting menu.
 Thevaluesshowningure39shouldonlypointouttheadjustmentoptions.Theydonotserveasreference
values for the setting.
Since the helicopter is already pre-set ex works, you should only make very small changes and check the
changedsettingswithtestights.
Figure 39