User manual

103
d) Dual Rate/Exponential Setting „D/R“
The Dualrate Function:
Withthehelpofthedualratefunction,theservodeectionsfortheroll,nodandtailfunctionscanbereducedby
pushingthetoggleswitch„DualRate“(seegure1,item20).Youcandothistosimplyandeasilyreducethereaction
sensitivity of a model which reacts too aggressively at full extension. Especially for beginners, models with reduced
servodeectionsarealoteasiertocontrol.
Whenamodelisusedforthersttime,itmightnotyetbeclear
how sensitively it responds to the control commands. Therefore
itisaprovenmethodtoreducethedeectionsduringight.
Exponential Function:
Incontrasttothedualratefunction,theenddeectionsofthe
servos are not reduced in the exponential function. The expo-
nential function merely reacts to the middle range of the control
curve. In practice, this means that the reaction to the control
stick is no longer linear,. but forms a curve.
To set the dual rate/exponential function, proceed as fol-
lows:
• Call the function settings menu.
• Select the menu item „D/R ADJ“ with the buttons „UP“ or
„DOWN“.
• Activate the menu item with the button „SELECT“.
The display shows the display for the roll function „AILE0“
or „AILE1“ with the currently set exponential and dual rate
values, depending on the position of the toggle switch „Dual
Rate“. Additionally, the adjacent gure shows the control
characteristic curve.
• Put the toggle switch „Dual Rate“ forward, so that the display
„AILE0“appearsforfulldeectionvalues.
• Push the button „SELECT“ so that the input function jumps
down to the exponential value „E“.
• Pushing the buttons „INC (+)“ or „DEC (-)“ sets the described
exponential value for the roll servo. At a positive value, the
servo reacts more strongly in the area of the middle position
of the servo stick; at a negative value, it reacts more weakly.
• The setting is saved automatically.
Figure 35