User manual

101
b) Servo End Deection Setting „EPA“
Usingtheservoenddeectionsettingyoucanpreciselydenethemaximumsizeofservotravelthatispermittedon
eachside.Theservoenddeectionfunctionistypicallyusedtoprotectservosfrommechanicallyhittinganobstacle
whendeectingtothefullextent.Youcansetavalueof0%-140%separatelyforeachcontrolfunctionandeachside.
The smaller the value, the shorter the servo travel.
To set the servo end deection, proceed as follows:
• Call the function settings menu.
• Select the menu item „EPA ADJ“ with the buttons „UP“ or
„DOWN“.
• Activate the menu item with the button „SELECT“.
Inthedisplayyouwillseedisplayitemsfortherstfourcon-
trol functions with the respective currently set values for the
servoenddeection.Thetrianglepointingtotherightshows
the value that can be set at the moment.
• Pushing the buttons „INC (+)“ or „DEC (-)“ sets the described
enddeectionto the rightfortherollservo.Thesettingis
saved automatically.
• Push the button „SELECT“ so that the triangle pointing to the
rightwilljumpbyonepositionandyoucansettheenddeec-
tion described for the roll servo to the left.
• Repeattheaboveprocedureuntiltheservoenddeections
of all six control functions have been programmed.
• Push the button „CLEAR“ to get back into the overview of the
function setting menu.
Figure 33