User manual

94
19. Binding Function
To enable transmitter and receiver to work together, they must be bound by the same digital code. In the delivery state,
transmitter and receiver are aligned with each other and can be used at once. The binding settings must be renewed
mainly after a replacement of the transmitter or receiver or to remove any interferences.
Since other manufacturers use different encoding methods, transmitter and receiver cannot be combined and opera-
ted with products of other companies.
Re-establishing the binding:
To recover the binding between the transmitter and receiver, the receiver must be removed from the model and all
servos,aswellasthegyroandtheightcontroller,mustbedisconnected.Inpractice,ithasprovenvaluabletoapply
the plug connections at the receiver with numbered stickers to be able to connect everything properly again later.
The receiver and the remote control transmitter must be in direct proximity to each other (max. 1m distance).
• Switchoffthetransmitter.
• Connect the enclosed programming plug (1) to the
„BATT“ connection of the receiver.
• Thepowersupplyofthereceiver(receiverbatteryor
speed controller of the model helicopter) is connected
to any output of the receiver.
• Switchonthereceiver.ThereceiverLED(2)startsto
ash.
• Pushthe bindingswitchatthetransmitter(alsosee
gure1,item12)andswitchthetransmitterwiththe
on/offswitch(alsoseegure1,item9).
 TheLEDdisplayatthetransmitter(alsoseegure1,
item11)islitgreenrstandstartsashingred.
• TheLEDinthereceiver(2)goesoutafterabrieftime
and binding is completed.
• Switchoffthereceiverandthenthetransmitter.
• Push the binding switch at the transmitter again so
that the transmitter works in regular operation next
time it is switched on.
• Removetheprogrammingplugandthepowersupply
from the receiver and install the receiver in the model
again.
• Connecttheservos,thegyroandtheightcontroller
to the receiver again.
 Observethecorrectconnectionsequenceandpolarityoftheplugconnectors.Whenbindingbetweenthetransmit-
ter and the receiver is correct, the LED in the receiver remains lit.
• Thencheckthefunctionofthemodelhelicopter.
The receiver or the servos now must react to the control signals of the transmitter. If this is not the case,
repeat binding.
Figure 34