User manual

Roll trimming:

If the helicopter tries to drift or tip to the right, reduce the speed until the helicopter is standing safely on its skids again.

Nowpushthetrimbuttonfortherollfunction(alsoseegure1,item7)totheleftforafewlatchingclicks.

Thenpushthecontrolstickforthepitchfunctionforwardcarefullyandcheckiftheadjustmentwassufcient.Repeat

the procedure until the model does not show any tendency to drift to the right.

If the helicopter tries to drift to the left, push the trim slider for the rolling function to the right.

Figure 29

Nod trimming:

If the helicopter tries to drift forward, reduce the speed until the helicopter is standing safely on its skids again. Now

pushthetrimsliderforthenoddingfunction(alsoseegure1,item5)downortowardsyourbodyforafewlatching

clicks.

Thenpushthecontrolstickforthepitchfunctionforwardcarefullyandcheckiftheadjustmentwassufcient.Repeat

the procedure until the model does not show any tendency to drift to the front.

If the helicopter tries to drift backwards, push the trim slider for the nodding function up or away from your body.

Figure 30

If the adjustment areas of the nod and roll trimming are not quite adequate for an optimum correction, you

adjust control of the main rotor blades mechanically. For further information, refer to the following chapter

„Fine-tuning the model helicopter“.