User manual

Switching analogue/digital servo „DS“ (see gure 20, item 4)

Thegyroisabletocontrolanalogueordigitalservos.Whenusingananalogueservo,theslider„DS“mustbesetto

„OFF“.

Whenadigitalservoisused,theslidingswitch„DS“mustbeputintheposition„ON“.Switchingispossiblewitha

small screwdriver.

Attention, important!

If an analogue servo is to be used and the slider „DS“ is set to „ON“, the servo can be destroyed by the high

control frequency.

Switching the servo rotating direction „DIR“ (see gure 20, item 5)

For the gyro to prevent the helicopter model from turning around the vertical axis (rotor shaft), it must always control

the tail servo to create an opposing turn.

For the gyro to be usable in different helicopter models, there is the option of using the slider „DIR“ to change the

effective direction of the automatic corrective control commands from normal („NOR“) to reversed (= „REV“).