User manual

76
12. Setting the Reverse Function Switch
Whentheswashplateandtherailrotorreactaccording
to the above movements, the function reversal switches
(1 - 6) are set correctly.
If the swash plate servos or the tail servo react precisely
opposite in one control movement, the respective func-
tion reversal switch must be switched.
The six switches (see gure 17) have the following functions:
Switches Function Factory Setting
1 Roll function REV
2 Nod Function REV
3 Motor function NOR
4 Tail Function REV
5 Gyro sensitivity REV
6 Pitch Function REV
Tochangethefunction,rstdisconnecttheightbatteryfromthehelicopterandthenswitchoffthetransmitter.
Then switch the respective switch from normal (= „NOR“) to reverse (= „REV“) or from „REV“ to „NOR“.
Then take the transmitter and the model into operation and test for correct control function.
Figure 17