User manual

73
e) Checking the Swash Plate Function
Afteryouhaveconnectedtheightbatteryandthetoggleswitchforthemotorofffunction(alsoseegure1,item17)
is in the rear position „1“, you can check the function of the swash plate:
Pitch Function
Push the control stick for the pitch and tail functions
(alsoseegure1,item14)slowlyfromthebottomtothe
top position. The toggle switch for the 3D-setting (also
seegure1, item 4)mustbe inthefrontposition „0“
for this.
The swash plate (1) will now move up slowly according
to the control stick position. It is important that the swash
plate is always aligned horizontally for this.
How far the swash plate is moved can be set with the
rotarycontrollerforthepitchpathlimitation(seegure1,
item 2). The farther the dial switch is turned to the right,
the longer the path of the swash plate up.
Turn the dial switch to the right until the stop and leave
it there.
Whenyoumovethecontrolstickdownagain,theswashplatemustmovedownagainandalwaysremainhorizontally
aligned.
 Fortestpurposes,youcanswitchthetoggleswitchforthe3Dsetting(alsoseegure1,item4)fromposition
„0“toposition„1“andwillquicklyndthattheswashplatetakesamuchlongerpathdownward.
 Therotorbladesarethenalignednegatively,sothatamodelhelicoptercapableofaerobaticscouldyin
backhoveright.Atthesametime,thethrottlecurveisswitched,sothatthemotorwouldrunat100%output
with the 3D Setting activated if the control stick for the pitch and tail function is in the bottom position.
Attention, important!
Since the model helicopter „Beginner Falcon V2“ is not designed for aerobatics, we urgently advise against
yingthemodelwiththe3Dsettingactivatedorcallingthesettinginight.
Figure 14