User manual

63
* The transmitter is technically able to control model helicopters and model planes. For this, the 5 DIP-switches
have the following functions:
DIP-
Switches
Switch position „OFF“ Switch position „ON“
Model helicopter
mode
Model airplane
mode
Model helicopter
mode
Model airplane
mode
1 Transmitter in model airplane mode Transmitter in model helicopter mode
2 No mixer function
(normal mode)
Wingmodel Swash plate mixer
(CCPM-mode)
Delta model
3 Controller VA
Pitch trim
Standard tail unit
without mixer
Controller VA
Gyro sensitivity
V tail mixer
4 Mode 1 Mode 2
5 Control encoder calibration „OFF“ Steuergeber -Kalibrierung „ON“
For the switch position „OFF“, the DIP switch must be switched down and for the switch position „ON“, the DIP switch
mustbeswitchedup.TheinputeldswithagreybackgroundshowthefactorysettingsfortheDIPswitches.
Attention!
The DIP switches 1 - 3 are pre-set ex works for the model helicopter „Beginner Falcon V2“ (see grey marking
in the table) and usually do not need to be changed. If the control stick assignment at the transmitter is
changed (from mode 2 to mode 1), the DP switch 4 must be changed.
DIP switch 5 is used to calibrate the control stick. For more information on this, see the chapter „Mainte-
nance and Care“.
** ThesimulatoroutputsocketcanbeusedtotapthePWMsignalforservocontrol,toalso,e.g.,controltheinterface
ofaightsimulatororteachertransmitterwithit.Furtherinformationonthiscanbefoundintheoperatinginstruc-
tions of the simulator.