User Manual

Reelcraft Industries, Inc. • [phone] / [phone] • Fax: [phone]
E-mail: [e-mail] • Internet: www.reelcraft.com
9.0 Provisioning Documentation Technical Data (see Appendix G)
8.0 Trouble Shooting Guide
Symptom Cause and Solution
Difficult to wind or rewind
hose.
- Hose was improperly wound back on reel, and the hose has over
lapped. Untangle the hose.
- The hand crank tensioner is fully or partially engaged. Release hand
crank tensioner.
- Insufficient grease in bearing. Add grease via grease fittings.
Leakage at inlet bearing.
- O-ring has failed. Replace O-ring.
- The spindle separated from the bearing. Replace O-ring and snap ring.
The drum wobbles.
- The bearings are out of alignment. Loosen bearings, align the shaft,
and tighten the hardware.
- The walls of the drum have been damaged. Straighten if minor, replace
drum if severe.
Guide rollers are binding.
- The rollers have been bent or bowed. Replace damaged rollers.
- Foreign material has become entangled in the ends of the rollers.
Remove rollers and clear debris.
6