Full Product Manual

9
Accessing Stored Measurements
The meter has the capability of storing up to 64 values during a single
measuring period. In order to recall these values, follow the steps below:
1. Press the MEM button four times and hold it down.
2. The meter will begin to countdown from 20 to 1 RPM indicating it is
compiling the stored values.
3. Once the countdown is completed, a total of the values stored
will display as "An XX", whereas XX will be the number of stored
measurements.
4. Press the MEM button repeatedly to scroll through each stored value.
Battery Replacement
1. When the bottom left corner of the LCD displays the batteries
should be replaced.
2. Open the Battery Cover located on the back of meter and remove
the batteries.
3. Replace with 4 new AA batteries, check that the polarization is
correct and reinstall the cover.
Accessories and Replacement Parts
R7100-TIPL Large Cone Adapter
R7100-TIP Cone Adapter
R7100-FUNNEL Funnel Adapter
R7100-SHAFT Shaft Extension Adapter
R7100-WHEEL Surface Wheel Adapter
RT100 Reective Tape for Tachometers
CA-05A Soft Carrying Case
R9940 Hard Shell Carrying Case
Don't see your part listed here? For a complete list of all accessories and
replacement parts visit your product page on www.reedinstruments.com.
REED Instruments
1-877-849-2127 | [e-mail] | www.reedinstruments.com