Full Product Manual

7
Surface Speed Measurements
1. Slide the function switch to the "m/min contact" position.
2. Install the surface wheel adapter on the instrument.
3. Press the Measure button while lightly pressing the surface wheel
against the surface being measured.
4. Release the Measure button when the display reading stabilizes
(approx. 2 seconds).
NOTE: If the inside part of the wheel is used (as shown in the
picture), measurements are required to be multiplied by 0.9
for an accurate measurement. This will not be the case when
using the outside part of the wheel.
Memory Recall
Accessing Maximum, Minimum and Last Values
The maximum, minimum and last values obtained prior to releasing the
Measure button will automatically be stored in memory.
IMPORTANT NOTE: All stored values will be erased from memory the
next time the Measure button is pressed.
continued...
Display
Reading
Max Value
Min Value
Last Value
Measuring Time
REED Instruments
1-877-849-2127 | [e-mail] | www.reedinstruments.com