Full Product Manual

6
Operating Instructions
Applying Reflective Marking Tape
1. Cut and peel the adhesive tape provided into approximately 0.5"
(12mm) squares.
2. Apply one square to each rotation shaft.
3. The non-reective area must always be greater than the reective area.
4. If the shaft is normally reective, it must be covered with black tape
or black paint before attaching reective tape.
5. The shaft surface must be clean and smooth before applying the
reective tape.
Photo Measurements
1. Apply a small piece of reective tape to the object being measured.
2. Slide the function switch to the "rpm photo" position.
3. Press the Measure button and align the visible light beam with the
applied target.
Contact Measurements
1. Slide the function switch to the "rpm contact" position.
2. Install the proper RPM adapter for your application on the shaft.
3. Press the Measure button while lightly pressing the rpm adapter
against the center opening of a rotating shaft.
4. Release the Measure button when the reading stabilizes
(approx. 2 seconds).
continued...
REED Instruments
1-877-849-2127 | [e-mail] | www.reedinstruments.com