Full Product Manual

8
6. If you have specic questions related to your application and/or
questions related to software setup and functionality please contact
the nearest authorized distributor or Customer Service at
[e-mail] or 1-877-849-2127.
Supplemental Operation Notes
1. The R6030 will automatically begin recording once setup is complete
and the datalogger is removed from the PC.
2. The R6030 needs to be reset from the software in order to start a
new data logging session.
3. Please note the time & date on the R6030 must be updated from
the software.
4. All stored data will be permanently erased when a new setup is
completed. To save data before it is erased, ensure you download
the existing data before setting up the datalogger for the next
recording session.
5. The "REC" will ash at the programmed rate when the unit is
datalogging.
6. When the set alarm limit is triggered, the alarm LED will ash once
each minute. When the alarm LED ashes red, this indicates that
the temperature value has exceeded the limit. When the alarm LED
ashes yellow, this indicates that the humidity value has exceeded
the limit.
7. To conserve battery power, LED ashing frequency can be adjusted
in the software. Alarm LEDs for temperature and humidity can be
disabled via software.
8. The datalogger should be placed in an upright position when
recording to avoid any damage to the sensors from possible
condensation.
REED Instruments
1-877-849-2127 | [e-mail] | www.reedinstruments.com