Full Product Manual

7
Operating Instructions
Software Installation
Install the included software by placing the supplied program disc in the
PC's CD-ROM drive. If the installation program does not automatically start,
open and browse the CD-ROM drive from your computer. Double click on
the setup le and follow the on-screen prompts to install the software.
If your computer does not have a CD drive please visit
www.reedinstruments.com/software to download the latest R6030 software.
If you are having trouble connecting to the R6030 it may be a USB
driver issue. Please note USB drivers are supplied on the included
CD and may need to be installed separately.
Battery Installation or Battery Replacement
A 3.6V battery is provided with the R6030. Please note that only a 3.6V
battery should be used with the instrument. In order to install the battery
follow the steps below:
1. Slide the protective boot off the R6030
2. Use a small Phillips head screwdriver to remove the battery cover
3. Install (or replace) the battery
4. Reinstall the battery cover and slide protective boot back on
Setting Up or Downloading Data
1. Once the software and battery have been installed, connect the R6030
to an available USB port on your PC with the included USB cable.
2. Double click the software icon on your desktop and the program will load.
3. Set up the data logger for a new session, or download saved data
from a previous recording.
4. When setup is complete or data has been downloaded, the R6030
should be removed from the USB port in order to preserve battery life.
5. Full specications and Operating System compatibility can be found
on the product page at www.reedinstruments.com
continued...
REED Instruments
1-877-849-2127 | [e-mail] | www.reedinstruments.com