R6010 Pinless Moisture Meter Instruction Manual REED Instruments 1-877-849-2127 | info@reedinstruments.com | www.reedinstruments.
Table of Contents Introduction................................................................................................. 2 Product Quality............................................................................................ 3 Safety.......................................................................................................... 3 Features....................................................................................................... 3 Specifications.............................
Product Quality This product has been manufactured in an ISO9001 facility and has been calibrated during the manufacturing process to meet stated product specifications. Safety Never attempt to repair or modify your instrument. Dismantling your product, other than for the purpose of replacing batteries, may cause damage that will not be covered under the manufacturer's warranty. Servicing should only be provided by an authorized service center.
Max: Auto Shut-off: Low Battery Indicator: Power Supply: Product Certifications: Operating Temperature: Storage Temperature: Operating Humidity Range: Dimensions: Weight: Yes Yes (30 secs) Yes 3 x AAA batteries CE 32 to 104°F (0 to 40°C) 14 to 140°F (-10 to 60°C) 0 to 85% 9.5 x 2.5 x 1.2" (242 x 63 x 30mm) 8 oz (226g) Instrument Description 1. 2. 3. 4. 5. 6. 7. 8.
Display Description 1. 2. 3. 4. 5. 6. 7. 8. Low Battery Indicator Data Hold Indicator Current Moisture Value Status Indicators MAX Indicator MAX Moisture Value MIN Indicator MIN Moisture Value Operating Instructions 1. 2. 3. Turn the meter ON by pressing the button. Please be advised that you must calibrate the meter before first use.
7. To take a measurement, position the sensor so that it is directly touching the surface being tested. The moisture sensor ball head must be kept perpendicular to the material being measured, pressed firmly on the surface and not slanted. 8. The LCD displays a relative moisture reading from 0.0% to 100.0% with programmable alarm indicators (DRY, RISK and WET) – See "Alarm Setup Mode" to program alarms. 9.
To change the WET alarm value, press the UP or DOWN buttons. Press the SET button to save the WET alarm value and to return to data hold mode. 9. If the moisture measurement exceeds the set RISK alarm setting, the meter will beep every second. If the moisture measurement exceeds the set WET alarm setting, the meter will beep every half second. 10. Press the MEAS button to exit data hold mode and resume normal operation. 7. 8. Backlighting Press the UP/ button to turn backlighting on and off.
Battery Replacement If appears on the LCD screen, the batteries should be replaced immediately. In order to replace the batteries, proceed with the following steps. 1. Turn off the meter 2. Remove the Phillips-head screw located on the battery compartment 3. Remove the battery cover 4. Replace the three (3) "AAA" 1.5V batteries 5.
Product Warranty REED Instruments guarantees this instrument to be free of defects in material or workmanship for a period of one (1) year from date of shipment. During the warranty period, REED Instruments will repair or replace, at no charge, products or parts of a product that proves to be defective because of improper material or workmanship, under normal use and maintenance. REED Instruments total liability is limited to repair or replacement of the product.
Test & Measure with Confidence Check out our latest Products! REED Instruments 1-877-849-2127 | info@reedinstruments.com | www.reedinstruments.
