Model R5004 Phase & Motor Rotation Tester Instruction Manual www reedinstruments REED Instruments com 1-877-849-2127 | info@reedinstruments.com | www.reedinstruments.
Table of Contents Safety............................................................................................. 3 Features.......................................................................................... 3 Specifications..............................................................................3-4 Instrument Description................................................................... 5 Operating Instructions.................................................................
Safety • • • • • • • • • • • • Protective equipment must be used to prevent shock and injury Use of this instrument in a manner not specified by the manufacturer may impair safety features/protection provided by the equipment Avoid working alone Damaged leads must be replaced Do not use this unit if it looks damaged Be careful when working above 30V AC RMS, 42V AC Peak, and 60V DC as such voltages pose a shock hazard Do not touch the probe contacts when in use, keep fingers behind the probe finger guards
Protection type: IP40 Protection levels: CATIII600V, CATIV300V Standards: DIN VDE 0411, IEC 61010 DIN, VDE 0413-7, IEC 61557-7/EN 61557-7 Operating voltage: Multiple connections: 40 to 600V AC between phases; Single connection: 120 to 400V AC between phases Power supply: 9V alkaline, IEC 6LR61 Power consumption: Max 20 mA Battery life: Minimum 1 year of average use Dimensions: 128 x 68 x 30mm Weight: 185g Includes: 3 test leads, 3 alligator clips, and one 9V battery Rotary Field Dire
Instrument Description 1. 2. 3. 4. 5. 6. 7. Test lead input jack L1, L2, L3 indicators Clockwise rotation LCD indicator Counter-clockwise rotation LCD indicator ON/OFF button ON/OFF indicator Orientation symbol Operating Instructions Determining the Rotary Field Direction 1. 2. 3. 4. Connect one end of the test leads to the meter. Make sure the L1, L2, and L3 test leads are connected to the corresponding input jacks. Connect the test probes to the other end of the test leads.
Phase Indication Table Non-contact Rotary Field Indication 1. 2. Disconnect all test leads from the unit. Position the unit on the motor so that it is parallel to the length of the motor shaft. The unit should be one inch or closer to the motor, and the bottom of the unit should be oriented towards the drive shaft. See Figure 1. (Figure 1) Motor Rotation 3. Press the ON/OFF button. The green ON indicator shows that the instrument is ready for testing. 4.
Motor Test Requirements See below for the minimum motor diameter and number of pole pair needed to obtain a reliable test result. • Number of pole pair • Rotary number of rotary field (1/min) at frequency (HZ) • Angle between poles • Minimum diameter of motor case Determining the Motor Connection 1. 2. 3. 4. 5. 6. Connect one end of the test leads to the unit. Make sure the L1, L2, and L3 test leads are connected to the corresponding jack. Connect the alligator clamps to the other end of the test leads.
Battery Replacement If this unit does not turn on, or shuts off during use, the battery needs to be replaced. To replace the battery, follow these steps. 1. Place this unit face down on a nonabrasive surface and loosen the battery-door screw with a screwdriver. 2. Lift the battery access lid away from the unit. 3. Remove the battery and replace with new 9V batteries. Observe the battery polarity shown in the battery compartment. 4. Secure the battery access lid back in position with the screw.
